View Full Version : Kitchen remodel, New bathroom
Eieio
January 15th, 2010, 08:39 PM
Kitchen Framing started
185318541855
Eieio
January 15th, 2010, 08:41 PM
New Bathroom being laid out
18561857 1858
ChrWright
January 15th, 2010, 08:47 PM
Got any plans we can see?
Blue
January 15th, 2010, 09:09 PM
a little lead dust in the trird stud bay
ChrWright
January 15th, 2010, 09:10 PM
Hard to tell, but it looks like the clean up guy got a little rambunctious on the plaster keys for the opposite side of the wall. :smash:
:grin:
Eieio
January 15th, 2010, 09:11 PM
Got any plans we can see?
They should be approved about 2 days after I finish :rolleyes3: :rolleyes3:
Eieio
January 15th, 2010, 09:14 PM
We are also Doing the basement. Turning it into an apartment
Eieio
January 22nd, 2010, 06:45 PM
The old Skylight is out the glass is going to be replaced and then we will set it back into place..
1898 1899 1900
Eieio
January 22nd, 2010, 06:50 PM
Plumbing is done for the new bathroom, kitchen re roughed in
We dropped the ceilings to cover the plumbing and remove the hideous ac bulkhead running down the middle of the living room and kitchen. one side will be a tray ceiling over the dining room table.
19011902 1903
Eieio
January 22nd, 2010, 06:52 PM
The homeowners are demoing a wall themselves to have an exposed brick entry wall..
1904 1905
PA Woodbutcher
January 22nd, 2010, 07:24 PM
Looks good. Great idea with the panned ceiling. Are you/they going to re-point and seal the brick in the entry?
Eieio
January 22nd, 2010, 07:25 PM
Looks good. Great idea with the panned ceiling. Are you/they going to re-point and seal the brick in the entry?
No re-pointing its not too bad.. Acid wash and seal it
nEighter
January 23rd, 2010, 12:41 AM
like that entryway. Is this what you normally do? Use the metal studs for res?
ChrWright
January 23rd, 2010, 10:06 AM
Plumbing is done for the new bathroom, kitchen re roughed in
We dropped the ceilings to cover the plumbing and remove the hideous ac bulkhead running down the middle of the living room and kitchen. one side will be a tray ceiling over the dining room table.
1901
Your CSST pipe doesn't look like it will pass. It can't be installed within 2" of any continuous metal--ducts, wires, pipes, steel framing, etc.
Eieio
January 23rd, 2010, 10:12 AM
Your CSST pipe doesn't look like it will pass. It can't be installed within 2" of any continuous metal--ducts, wires, pipes, steel framing, etc.
It will when it gets strapped up.. It is going all the way to the attic for the ac unit. the HVAC guy has to tell us where he needs it to go then we will strap it up.. It may go in the room behind that wall.
Eieio
January 23rd, 2010, 10:12 AM
like that entryway. Is this what you normally do? Use the metal studs for res?
Usually for light framing or what I call design framing.. We use it a lot in basements to..
ChrWright
January 23rd, 2010, 10:13 AM
It will when it gets strapped up.. It is going all the way to the attic for the ac unit. the HVAC guy has to tell us where he needs it to go then we will strap it up.. It may go in the room behind that wall.
Word to your mother. :2thumbsup:
Eieio
January 23rd, 2010, 10:15 AM
Word to your mother. :2thumbsup:
We have 3 more ward flex lines to run. One for the stove, tankless water heater and a future fireplace.. All of those will come from the basement through the floors.
We have to frame out down there next week.. I will take some pics of the attic and basement later today
nEighter
January 23rd, 2010, 10:34 AM
I love pics man! Good stuff. How long does it take to get paid on these 203K projects?
Eieio
January 27th, 2010, 04:52 PM
We are starting to Demo out the basement.. The Plumber had to do some Ground work so we could close in the Floors above
1928 1930 1931
1932
Eieio
January 27th, 2010, 04:57 PM
1933 1934 1935
ChrWright
January 27th, 2010, 05:22 PM
Is that a bit of fire damage down there? An old coal furnace?
orson
January 27th, 2010, 06:55 PM
Rory can you point out the pros/cons of using steel framing vs. wood on these types of projects?
I've done some light and heavy guage steel framing on commercial projects(along with a lot of cursing) but I never really considered it for residential remodeling.
Eieio
January 27th, 2010, 08:02 PM
Is that a bit of fire damage down there? An old coal furnace?
Yep old coal furnace, The duct work was still intact. I will try to remember to take some pics.. The old duct work is amazingly still will intact
Eieio
January 27th, 2010, 08:04 PM
Rory can you point out the pros/cons of using steel framing vs. wood on these types of projects?
I've done some light and heavy guage steel framing on commercial projects(along with a lot of cursing) but I never really considered it for residential remodeling.
Speed of framing and that was done by one guy in 5 hours.. We use metal studs in basement framing 90% of the time as well..
SLS-Construction
January 28th, 2010, 01:24 AM
Owen, don't forget how much straighter the wall is and there is no need to check for the crown. If I could get them around here, I would be using them.
Eieio
March 24th, 2010, 09:48 AM
We are wrapping up the Bathroom and Kitchen this week. waiting for the shower door and paint selection..
2346
2347
2348
Eieio
March 26th, 2010, 03:52 PM
2362
2363
2364
2365
Eieio
March 26th, 2010, 03:53 PM
Cabinets Installed along with the new tankless water heater, waiting for the tops to come in..
2366
2368
2367
SLS-Construction
March 26th, 2010, 04:56 PM
You finally got out of the office today? Both projects are lookin good
Eieio
March 26th, 2010, 05:07 PM
Thanks Sean. and of course I picked the nastiest day of the week to go outside and play.. :rolleyes3:
neolitic
March 26th, 2010, 05:53 PM
I do like that tile. http://i634.photobucket.com/albums/uu61/neoliticman/smilie/smiliethumbsup.gif
vBulletin® v3.8.6, Copyright ©2000-2012, Jelsoft Enterprises Ltd.